Chicago Industrial Reuse and Parts Blog-Newsgroup > North Chicago
> New
> Industrial
> Restaurant
> Miller alt 304 s-64M welder wire feeder xmt mig tig
Miller alt 304 s-64M welder wire feeder xmt mig tig
Miller ALT 304 Multiprocess Inverter welder. (6ft cord with no plug)
Mig, Pulsed Mig, DC Tig, Stick, Arc Gouging
S-64M Wire feeder (welder pulse capable with this wire feeder)
Ground and Stinger leads (15ft each)
New binzel Omega 3 Mig gun with .052 - .062 liner (can be changed to most any size)
WP-26V Weldcraft Tig torch. Has an eye on the end. Will need a Dinse connector to connect to welder (was using with High freq unit)
.045 serrated and 1/16" U cogged drive rolls (4 each size)
Smith flow meter with gas hose
All the specs at millerwelds.com
The welder is in excellent condition. Very little use and it shows. Has a couple of noticeable scratches on the side. you can see them in the pictures.
Wire feeder works great but has had some use. There is some paint splatter on the front face
Tig torch has some frays in the covering of the rubber gas line. No leaks and works fine but have included a new vinyl gas line
Flow meter is nice and in good working order
Foot pedal is in average used condition
Have used this welder for both Mig and DC TIg with great results
Just more welder than I need at this point
Had a conversation recently with Miller tech support. Wanted to refresh my memory on the ALT-304 Features
The ALT-304 uses the autoline technology were as the XMT-304 uses autolink. The autoline connect to any voltage between 190V and 600V single or 3 phase. The auto link connects to either 230V or 460V plus or minus 10% . The autolink is a problem if you connect at a lower voltage and that voltage changes as in the case of a generator starting up.
The ALT technology is still current and uses the same engine as the higher end AXIS series
The arc is almost identical to the XMT-304 with the ALT having a little better low end
Has shown good reliability and is a proven design
Miller tech support is great about answering any question on their welders
Cash at pickup if local, or Pay-Pal
For further information: E-mail or (***)-489-5552
Sales tax charged for Colorado addresses
